PWM Boost Control Kit
This kit allows you to use the boost control or the EGR (Pin A11) features available in your favorite honda/acura tuning software
This Kit Contains:
1x Diode for D14
2x Resistor for R70 and R71
1x Transistor for Q20
1x Mosfet for Q29
**Kits are for USDM OBD1 Honda/Acura ECU ONLY**
Install instructions:
-Desolder the areas marked D14,Q29,R70,R71
-Solder the large Mosfet transistor into the space marked Q29
-Install the diode into the space marked D14. Be sure the side of the diode with the grey stripe faces to the left.
-Solder the R70 marked resistor in the space labeled R70.
-Solder the R71 marked resistor in the space marked R71
**resistors can be installed in either direction**
-Install the small transistor with the markings on the transistor facing you (towards label on front of ECU) in space labeled Q20
-Be sure to trim the remaining 'legs' of the components off from the back side of the ECU
Looking for a tuning software for honda/acura 88-00?
Visit BMTune for more informations.
FOR MORE INFORMATIONS
Contact Bouletmarc
By Email OR On Facebook
